User guide

Connecting the transmitter to the sensor
Before connecting the transmitter to the sensor, you must have the transmitter fully charged and set up (see
Charging the transmitter and Entering the transmitter ID sections in this chapter). You must also have the
features set up and the sensor inserted (see the instructions in this chapter and those provided with your
sensor).
To connect the transmitter to the sensor:
1 Connect the transmitter to the sensor, as shown.
NOTE: Overtape is not shown in the following steps.
2 The green light on the transmitter will flash. If the light does not flash, disconnect it from the sensor,
wait for several seconds, and reconnect. If the transmitter light still does not flash, charge the
transmitter.
3 Cover the transmitter with the Enlite sensor’s adhesive tab.
Sensor features136