User guide

Once the settings are programmed, you do not have to program them again unless the values change. After
you program one setting, the screen will automatically go to the next required setting. After you program
all your settings, review them as described in this section to make sure they are set correctly.
Instructions for programming the Bolus Wizard feature settings are in the next paragraphs. Program your
settings in the order described to make sure you program all the settings. If you have not completed setting
up all of the required settings, MISSING INFO screen appears. It lists the required settings for this feature.
You must program the listed settings before you can use the Bolus Wizard feature.
Turning on the Bolus Wizard feature
1 Go to the EDIT SETTINGS screen.
Main > Bolus > Bolus Setup > Bolus Wizard Setup > Edit Settings
2 The EDIT SETTINGS screen appears with Wizard: Off selected. Press ACT.
3 The WIZARD ON/OFF screen appears. Select On, then press ACT.
4 The EDIT SETTINGS screen appears, showing that the wizard is now turned on. You are now ready to
select your carb units.
Selecting the Carb units
The carb unit setting lets the pump know which way to count your carbohydrates (grams or exchanges).
1 Make sure the EDIT SETTINGS screen is open.
Main > Bolus > Bolus Setup > Bolus Wizard Setup > Edit Settings
2 Select Carb Units, then press ACT.
3 The CARB UNITS screen appears. Select Grams or Exchanges, then press ACT.
4 The EDIT SETTINGS screen shows the carb units you selected. You are now ready to set your carb/
exchange ratios.
Using the Bolus Wizard feature80