User Manual
TABLE OF CONTENTS 1. Before You Begin................................................................................3 What is Included............................................................................................ 3 Unpacking Instructions .................................................................................. 3 Text Conventions .......................................................................................... 3 Icons ..........................................................
1. BEFORE YOU BEGIN What is Included Unpacking Instructions • • • • • 1 x SlimPAR™ 64 1 x Power Cord Hanging Bracket with Mounting Hardware 1 x Warranty Card 1 x Quick Reference Guide Immediately upon receiving this product, carefully unpack it and check the container in which you received it. Make sure that you have received all the parts indicated above and that they are all in good condition.
Page 4 of 12 • Always make sure that the voltage of the outlet to which you are connecting this product is within the range stated on the decal or rear panel of the fixture. • This product is for indoor use only! To prevent risk of fire or shock, do not expose this fixture to rain or moisture. • Make sure there are no flammable materials close to the unit while operating. • Always install this product in a location with adequate ventilation, at least 20 in (50 cm) from adjacent surfaces.
2. INTRODUCTION Product Overview Microphone Sensitivity Adjustment Knob Control Panel LED Display Satellite™ 12 V Input Power In Fuse Holder Power Out Bracket Adjustment Knob SlimPAR™ 64 User Manual Rev.
3. SETUP AC Power This product has an auto-ranging power supply and it can work with an input voltage range of 100~240 VAC, 50/60 Hz. To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its average current draw under normal conditions.
Mounting Before mounting this product, read and follow the safety recommendations indicated in the Safety Notes section (page 2 of this manual). Orientation The SlimPAR™ 64 may be mounted in any position, provided there is adequate room for ventilation around it. Rigging Before deciding on a location for this product, always make sure that it will be easy to access the unit for maintenance and programming purposes.
4. OPERATION Control Panel Operation To access the control panel functions, use the four buttons located underneath the display. Please refer to the Product Overview (page 5) to see the buttons location on the control panel.
Configuration (Standalone) Set this product in one of the standalone modes to control it without a DMX controller. • Connect this product to a suitable power outlet. Never connect a fixture that is operating in any standalone mode, whether Static, Automatic, or Sound to a DMX string connected to a DMX controller. This is because fixtures in standalone mode may transmit DMX signals that could interfere with the DMX signals from the controller.
• Configure all the slave units before connecting the master unit to the DMX daisy chain. • Never connect a DMX controller to a DMX string configured for Master/Slave operation because it may interfere with the signals from the master unit. • Do not connect more than 31 slave units to the master unit.
6. TECHNICAL SPECIFICATIONS Dimensions and Weight Length Width Height Weight 9.7 in (246 mm) 11.1 in (282 mm) 2.5 in (64 mm) 2.8 lbs (1.3 kg) Note: Dimensions in inches rounded to the nearest decimal digit. Power Range Voltage Selection Switching (internal) 100~240 V, 50/60 Hz Auto-ranging Parameter 120 V, 60 Hz 230 V, 50 Hz 36 W Power 32 W Operating current 0.3 A 0.
Returns Send the merchandise prepaid, in the original box, and with its original packing and accessories. CHAUVET® will not issue call tags. Call CHAUVET® and request a Return Merchandise Authorization (RMA) number before shipping the fixture. Be prepared to provide the model number, serial number, and a brief description of the cause for the return. The user must clearly label the package with a Return Merchandise Authorization (RMA) number. CHAUVET® will refuse any product returned without an RMA number.
