Owner`s manual

GB - 13

PLAYING A DISC

This owner’s manual explains the basic instructions of this unit. Some DVD discs are produced

in a manner that allows specific or limited operation during playback. As such, the unit may not

respond to all operating commands. This is not a defect in the unit. Refer to the instruction notes

of discs.

“ ” may appear on the screen during operation. A “ ” means that the desired operation

is not permitted by the unit or disc.

Basic playback

Playing a Disc

1. Set POWER ON/STANDBY switch to POWER ON.

2. Set DVD/AV IN switch to DVD.

See CUSTOMIZING THE FUNCTION SETTINGS (page 23 to 27) before proceeding to step 4.

3.Press the left side corner of the disc door to open the disc door.

4.Hold the disc by its sides and carefully make it fit onto the central support of compartment with the label side

facing towards you until you hear a “click”.

5.Pushing the disc door to close the disc door.

It takes a short while for your unit to load the disc. After loading, for some discs, the unit will automatically start

playback of the disc.

6.Press the

PLAY button.

Notes:

• Let the disc door open completely before removing the disc. Pushing the disc door to close the disc door after you

remove the disc.

DVD

Pausing playback (still mode)

Press the

PAUSE button. To resume normal playback, press the PLAY button.

Stopping playback

Press the STOP button at the location where you want to interrupt playback. To resume playback at the position

where the disc was stopped, press the

PLAY button.

If you press the

STOP button twice, the unit’s memory will be cleared and pressing the PLAY button will reset

the disc to the beginning.

To skip to a different track

• Press the PREV button once to skip to the start of the previous track.

• Press the NEXT button to skip to the next track.

• For audio CD disc, use the number buttons (remote control only) to jump straight to that track number.

(continued to next page)(continued to next page)

(continued to next page)