User manual

SYMPTOM CAUSE (AND REMEDY)
No power. , Check that the AC power cord is connected.
• The unit is not turned on.
The remote does not • Remove any obstacles between the remote and the unit.
function. • Use the remote near the unit.
• Point the remote at the remote sensor on the unit.
DVD • Replace the batteries in the remote with new ones.
No sound or 0nlya • Make sure that you select DVD mode.
very low-level sound , The system is in pause mode. press the • PLAY button to return to normal
is heard. PLAY mode.
Fast-forward or fast-reverse is performed. Press the • PLAY button to retur n
to normal play mode.
• Make sure the AUDIO t VIDE© output and AV IN input connections are Correct.
The DTS DVD disc cannot be decoded to have speaker output.
• The unit is too hot. Shut off the unit for 30 minutes to cool it down.
No picture. • The region number of the disc does not match the region number of this
unit. ___
The picture is not • Ctean the disc.
clear. • The disc is scratched.
Severe hum or noise • The plugs and jacks are dirty. Wipe them with a cloth slightly moistened
is heard, with alcohol.
• Clean the disc.
The disc does not • Thereis no discinside ('!No Disc" appearson the screen).
play. !nsert the disc correctly with the playback side facing towards.
Clean the disc.
A non-valid disc has been inserted. The unit and disc regi0n number are
incompatible.
' Condensation may have formed inside the unit due to a sudden change in
temperature, wait about an hour for it to clear and try again.
TV
Bad Picture (snow, • Check the location of the antenna and adjust it if necessary.
multipe images, • Make sure the antenna cable is firmly connected.
distortion, blurry) • Make sure all input cables are firmly connected.
Black and white . ChecktheVIDEOMENUwithintheTVSETUPMENU.
pi6ture..Check to make sure the program you are watching is broadcast in Color
and not black & white.
No picture or sound. . Make sure the unit is plugged in and turned on.
. Make sure that TV mode is selected.
. Try a new channel to check for possible station trouble.
• Make sure the antenna is connected properly.
• Increase the volume.
• Make sure the antenna or audio video source device is working properly.
• Make sure all cables are firmly connected.
• Check for local interference.
Colored patches of. Make Sure there are no unshielde d electrica! devices nearby that are
picture . causing interference.
• Turn the unit off for 30 minutes, then try it again.
No sound is output • Check the connection between this unit and the HDMI out jack of other
from the HDMI out equipment.
• See if the TV supports this 480p/576p/720p/1080i DVD system.
• Check your TV system setup correctly.
• Make sure your TV supports HDCP (High Bandwidth Digital Content
Protection).
E - 29