Instruction manual
The symbol for Class II 
(Double Insulation)
CAUTION
•  DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY 
REPLACED.  REPLACE  ONLY  WITH THE  SAME  OR 
EQUIVALENT TYPE.
•  TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE 
OF PLUG TO WIDE  SLOT  OF WALL  OUTLET, THEN 
FULLY INSERT.
•  U S E  O F C O N T RO L S OR  A D JU S TM E N TS  O R 
PERFORMANCE  OF PROCEDURES  OTHER  THAN 
THOSE  SPECIFIED  MAY  RESULT  IN  HAZARDOUS 
RADIATION EXPOSURE.
WARNING :
•   TO  PREVENT  FIRE  OR  SHOCK  HAZARD,  DO  NOT 
EXPOSE THIS UNIT TO RAIN OR MOISTURE. DO NOT 
PLACE OBJECTS  FILLED WITH LIQUIDS ON OR NEAR 
THIS UNIT.
•   SHOULD ANY TROUBLE  OCCUR,  DISCONNECT THE 
AC POWER  CORD AND  REFER  SERVICING TO  A 
QUALIFIED TECHNICIAN.
WARNING:
Changes  or modifications  to this  unit  not  expressly 
approved by party responsible for  compliance could 
void the user authority to operate the unit.
PLACEMENT INFORMATION
•  Do  not  use  this unit  in places which are extremely 
hot, cold, dusty or humid.
•  Do not restrict the air ow of  this unit by placing it 
somewhere with poor air ow, by covering it with a 
cloth, or by placing it on bedding or carpeting.
SAFETY INFORMATION
•  When connecting or  disconnecting the AC power 
cord, grip the plug and not the cord itself. Pulling the 
cord may damage it and create a hazard.
•  When you are not going to use the unit  for a long 
period of time, disconnect the AC power cord.
CONDENSATION INFORMATION
•  When left  in a  heated room where it  is warm  and 
damp,  water  droplets  or  condensation may  form 
inside  the equipment. When  there is condensation 
inside the unit, the unit may not function normally. 
Let the unit  stand for 1-2 hours before turning the 
power on or gradually heat the room and allow the 
unit to dry before use.
RATING PLATE LOCATION
The rating plate is located on the rear of the unit.
FCC STATEMENTS
NOTE: This unit has been tested and found to comply 
with the limits for a  Class  B digital device,  pursuant 
to Part 15 of the FCC Rules. These limits are designed 
to  provide  reasonable  protection  against  harmful 
interference  in  a  residential  installation. This  unit 
generates, uses and can radiate radio frequency energy 
and,  if not installed and used in accordance with the 
instructions, may cause harmful interference to radio 
communication. However, there is no guarantee that 
interference will not occur in a particular installation. 
If this unit does  cause harmful interference  to  radio 
or television reception, which can be  determined by 
turning the unit o and on, the user is encouraged to 
try to  correct the  interference by  one or more of the 
following measures:
-  Reorient or relocate the receiving antenna.
-  Increase  the  separation  between  the  unit  and 
receiver.
-  Connect the unit into an outlet on a circuit dierent 
from that to which the receiver is connected.
-  Consult  the  dealer  or  an  experienced  radio/TV 
technician for help.
WARNING : TO REDUCE THE RISK  OF  ELECTRIC 
SHOCK, DO  NOT  REMOVE  COVER  (OR  BACK). 
NO  USERSERVICEABLE  PARTS  INSIDE. REFER 
SERVICING TO QUALIFIED SERVICE PERSONNEL.
The exclamation point within an equilateral 
triangle  is  intended  to  alert  the  user  to 
the presence of  important  operating  and 
maintenance (servicing) instructions in the 
literature accompanying the appliance.
The lightning ash with arrowhead symbol, 
within an equilateral triangle, is intended to 
alert the user to the presence of uninsulated 
“dangerous voltage” within the product’s
en c l o su re  th a t  ma y  be  of  suf f i c ie n t 
magnitude  to  constitute a risk  of  electric 
shock to persons.
 SAFETY PRECAUTIONS
1










