User`s guide
Table Of Contents
- ■ Features of this Product
- ■ Contents of Package
- ■ Compatible Models of iPod/iPhone and PC (OS)
- ■ How to Use this Product
-  1. Checking the Remaining Battery of this Product
-  2. Charging the Built-in Battery of this Product
-  3. Charging iPod/iPhone by this Product's Built-in Battery
-  4. Connecting with iPod/iPhone
-  5. Listening to Music in iPod/iPhone in "AMP" Mode
-  6. Synchronizing with iPod/iPhone and iTunes on Computer
-  7. Listening to Music on Computer in "USB DAC" Mode
-  8. Connecting to Other Audio Devices
-  9. Setting Other Functions
-  10. Setting Gain
-  Troubleshooting
- Specications
- Cautions on Use
- Product Support
- Trademarks and Registered Trademarks
6
5.
Listening to Music in iPod/iPhone in "AMP" Mode
Turn the power ON by the power switch volume knob
and set the toggle switch (L) to "
" position.
Once this product and iPod/iPhone are correctly
connected (authenticated), the toggle switch LED turns
on red or green.
* If the toggle switch is blinking, iPod/iPhone may not be
connected with this product at all, or it may not be correctly
connected (authenticated).
In such case, disconnect iPod/iPhone once and recoonect,
or turn the power OFF by turning the power switchvolume
knob coun
terclockwise all the way until it clicks, and then
turn the power ON again.
6. Synchronizing with iPod/iPhone and
iTunes on Computer
Connect the USB micro B connector on the rear panel of
this product and your computer with the supplied USB
cable.
By setting the toggle switch (L) on the front panel to
"
" mode, it enables synchronization with iTunes
on your computer. "SYNC" state is the same as if iPod/
iPhone was directly connected to your computer.
CAUTION
Do not change the switches or disconnect the
microUSB cable during synchronization.
1
1
2
2
USB