User`s manual

Bucket Fan

BEFORE PERFORMING ANY MAINTENANCE ALWAYS ENSURE THAT THERE IS NO POWER TO THE FAN,

YOU MUST DISCONNECT THE ELECTRICITY AT THE MAIN POWER SOURCE!

Annually:

1) Check to make sure the bolts are tight.

2) Check impeller for dirt or other matter. Clean if necessary.

• To clean, remove the four screws that secure the grille to the metal case.

• Remove the grille from the case and clean the blades with warm, soapy water. Avoid splashing

water on the motor.

• Wipe surfaces dry.

• Also clean the inside of the metal case while you are at it.

• Re-attach the grille to the case.

• Electrical wiring should only be done by a quali ed electrician.

• Warranty will not cover equipment damage or failure that is caused by improper installation.

• If the fan did not come pre-wired or if a new wire is to be used, wire the fan as shown in the Figure

6 below.

• Use 18 AWG or greater wire.

WIRING THE FAN

Fig. 6

Bucket Fan 420 Bucket Fan Whisper 420

1.0 A

Bucket Fan 1055 Bucket Fan Whisper 1055

1.0 A

Bucket Fan 1460 Bucket Fan Whisper 1460

2.0 A

BLACK (LINE)

GREEN (PROTECTIVE EARTH)

WHITE (NEUTRAL)

Motor run capacitor

Motor terminal box

~120 VAC 60 Hz

MAINTENANCE