Technical Specifications

















OPTIONAL
DUCT
COVER
2 OPTIONAL
DUCT
COVERS
COH Equipped with halogen lighting. Not available with heat lamps. Shown with optional duct cover
(sold separately). Optional duct covers available in standard and custom sizes.
ISLAND RANGE HOOD SPECIFICATIONS
1100 CFM T2+ 200 Dual Blowers
(Top View)
COH
550 CFM T200 Dual Blower
(Top View)
*Recommended mounting
height is for optimum
performance.
Centerline
of Hood
Centerline
of Hood
Electrical
Vent Holes
¾”
2 ⁄”
5” x 16”
Exhaust
Opening
8” Transition
Opening 9”
Above Top
of Hood
11”
11”
Centerline
of Hood
Electrical (2)
Vent Holes
2 ⁄”
Centerline
of Hood
¾”
5” x 16”
Exhaust
Opening (2)
8” Transition
Opening (2)
9” Above Top
of Hood
12"
9"
9"
16"5"
8" Round 8" Round
VP565 Standard Transition
(Included)
Transition Installed
(Side View)
Connection Diagram (36” - 54”) Connection Diagram (60” - 66”) Recommended
Mounting Height*
U
L
CUS
R
Electrical/Mechanical Specications For Blower Units
Model Volts Amps* Hz RPM
CFM
SP@0.0"
Equivalent CFM
•
CFM
SP@0.1"
CFM
SP@0.2"
CFM
SP@0.3"
Minimum Round
Duct Size
Sones
#
T200 Island Dual 115 2.9 60 1550 550 900 507 471 431 8" (50 in.
2
) 6.0
* Add 0.5 amp for each halogen light. Hood is available with halogen lights (4 lights: 36" - 59", 8 lights: 60" - 66", +2 lights for each 14" if over 66").
• BecausetheMagicLung
®
blowerusescentrifugalltrationratherthanconventionalbafeormeshlters,theMagicLung
®
blower can handle cooking equipment with higher cubic feet per minute (CFM) requirements and can deliver equivalent CFM much more
efcientlythanotherthanotherltrationsystems.WhencomparingtheMagicLung
®
withotherblowerunitsmadebyothermanufacturers,usethe“EquivalentCFM”.
# RatingsinaccordancewiththeStandardTestCodebytheEnergySystemsLaboratoryoftheTexasEngineeringExperimentStation.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE Rev. 0412A
1 ½”
1 ½”
Island Duct Cover
Mounting Holes
(Top View)
⁄” Dia.