Installation Instructions

Page 5L116 1210A
Flat Nylon Washer
Wood
Screw
Trim Piece
Countersunk
Nylon Washer
Installation Details Continued
9) Install transition in the exhaust collar(s). Seal connection with duct tape. Note: The transition must engage inside the
exhaust collar. While aligning the duct connection and guiding the wires, lift the liner up into the enclosure ushing
the bottom edges of the liner and the enclosure. Duct and transition should connect together as the liner is raised into
place. Wood strips may be necessary to ll any gaps between the opening and the liner if the opening in the wood
surround is larger than the liner.
10) Install a wood screw with a countersunk washer and a at
washer into each mounting hole along the bottom edge of the
liner. Note: The hardware used in this step can be found in the
liner trim kit that was previously removed from the packaging
in Step 4.
11) Install the trim piece for the back and front of the liner (provided
in the liner trim kit) by hooking one side under the bottom
edges of the back countersunk washers. Snap the trim piece
over the top of the countersunk washers by applying pressure
upward and toward the liner wall. Repeat this process for the
side trim pieces (provided in the liner trim kit). Note: It may be
necessary to lightly tap the trim piece with a rubber mallet.
12) Plug the motors into the liner and reinstall the blower motor retaining screws that were previously removed in Step
6. Note: The side of the motor box where the “black” motors mount is labeled to ensure the motors are installed back
into the hood in the proper position.
13) Replace the blower housings and the blower shields. Make sure that the dampers open and close smoothly.
14) Refer to the Owner Maintenance Guide Operating Instructions for proper hood operation. Test all blower and light
functions to ensure they are operating properly.
Liner Trim Kit