Installation Instructions

Page 4L120 1210A
Centerline
of Hood
Electrical
6 ¼”
Vent Holes
8” Transition
Opening 7”
Above To p
of Hood
5” x 16”
Exhaust
Opening
Centerline
of Hood
9"
16"5"
8" Round 8" Round
7"
21"
Centerline
of Hood
8” Blower
Outlets
Centerline
of Hood
Electrical
6 ¼”
10 ½”
Vent Holes
12” Transition
Opening 9 ¼”
Above To p
of Hood
12" Round
12" Round
11 ¼"
8" Round 8" Round 8" Round
9 ¼"
23 ¼"
Brass Screws
A
Blower Wheel
B
Blower Housing
Installation Details Continued
8) Remove the blower mounting assembly by removing the 12 screws around the blower mounting plate. Unplug the
electrical connector(s) and set the blower assembly aside, taking care not to damage blower wheels.
9) Install an appropriate 1/2” UL listed electrical wire clamp through the electrical strap(s) on the top of the hood deck.
Install electrical wiring from the service panel to the hood location for each blower assembly. Consult the connection
diagrams (above) for further details on electrical placement. Support the hood beneath the location where it will hang
and feed the electrical wire(s) into the wire clamp(s). Tighten the wire clamp(s).
Connection Diagram (54”- 66” Widths)
Connection Diagram (42”- 48” Widths)
550 CFM T200 Dual Blower
(Top View)
VP565 Transition
(Included)
Transition Installed
(Side View)
1100 CFM T400 Cluster Blower
(Top View)
Transition Installed
(Side View)
VP564 Transition
(Included)
Warning: Make sure power is off and locked at the service disconnecting
means on the service panel during installation.
6) Remove the blower shields (A) by loosening the two brass screws on the bottom of the shield. Gently close the back
draft dampers from the top side of the hood. To remove the blower housings, unsnap the suitcase latches (B) (one on
each side of the housing). The housings should be pulled forward and gently “tipped” to clear the blower wheels and
then out of the hood.