Installation Sheet

Page 4L152 0611A












6" Round


Motor
Cooling
Vent

Electrical



8" Round












Motor
Cooling
Vent
Electrical


























8" Round 6" Round



Motor
Cooling
Vent















 



8" Round
 
8" Round
Motor
Cooling
Vent
Electrical (2)
Model Width A Width B
CWEH9-342 8" 8"
CWEH9-348 10" 10"
CWEH9-354 11" 11"
CWEH9-360 12" 12"
Model Width A Width B
CWEH9-448 11" 11"
CWEH9-454 11" 11"
CWEH9-460 12" 12"
CWEH9-466 13" 13"
Installation Details Continued
Connection Diagram (30”- 48” Widths)
Connection Diagram (42”- 60” Widths)
Connection Diagram (48”- 66” Widths)
900 CFM B200 Dual & B100 Single Blower
(Top View)
1200 CFM Double B200 Dual Blowers
(Top View)
5) Remove the hood from its packaging and place the back of the hood on the oor or countertop in front of the wall
where it will hang.
6) Remove the shipping tape that is securing the E-Z Clean shield(s) inside the hood. Remove the E-Z Clean shield(s) by
lightly pulling it toward the front of the hood. Gently close the back draft damper(s) from the top side of the hood. To
remove the blower housing(s), unsnap the suitcase latches (one on each side of the housing). The housing(s) should
be pulled forward and gently “tipped” to clear the blower wheel(s) and then out of the hood.
7) Remove the three screws retaining the blower motor(s). Unplug
and remove the motor(s), taking care not to damage the blower
wheel(s). It is not necessary to remove the blower wheel from
the motor.
300 CFM B100 Single Blower
(Top View)
600 CFM B200 Dual Blower
(Top View)
Connection Diagram (30”- 54” Widths)
Outlet Spacing for
900 CFM Models
Outlet Spacing for
1200 CFM Models