Specifications

This unit has been checked out and started according with
the above procedures and completed forms and is operat-
ing satisfactorily.
After 24 hours of satisfactory operation, shut down the
unit and check all foundation bolts, fan set screws and ter-
minals. Tighten where required.
Additional Comments:
_________________________________________________
_________________________________________________
Start-up
By: _______________________________________________
Date: _____________________________________________
Email: ____________________________________________
Company Name: ___________________________________
Telephone: ________________________________________
Email to Tech Support ([e-mail]) or
fax to 306-244-4221.
Table G3: Start-up Readings
Mode of Operation Heating Cooling
Power supply
Nameplate voltage
Voltage at disconnect no motors
Power supply
with all loads
connected
Voltage at full load
Supply fan
Full load amps
Amp draw
Overload amp setting
RPM
Exhaust fan
Full load amps
Amp draw
Overload amp setting
RPM
Airside
Airflow CFM
Supply
Exhaust
Temperature °F
db/wb
Outdoor entering
Supply leaving
Return entering
Exhaust leaving
Static pressure
inches w.c.
Outdoor duct
Supply entering
Supply duct
Return duct
Exhaust duct
Electric
heating
Stage 1 2 3 4
Amp draw – L1
Amp draw – L2
Amp draw – L3
Start-up Readings
• Allow unit to reach steady state before taking readings.
• Complete based on options included with the unit.
Serial Number: _____________________________________
VCES-HRV-IOM-1C – HRV600i, HRV700i, HRV1200i
31