Specifications
Table Of Contents
- Table of Contents
- Nomenclature
- Safety Considerations
- General Information
- Installation
- Start-up
- Maintenance
- Appendix A: Equipment Data
- Appendix B: Dimensional Drawings
- Appendix C: Flow Measuring Station and Balancing Damper Positions
- Appendix D: Drain Connections
- Appendix E: Mounting Diagrams
- Appendix F: Terminal Control Diagrams
- Appendix G: HRV600i, HRV700i and HRV1200i Start-up Form and Checklist
- Appendix H: Electrical Control Box and Wire Connections
- Appendix I: Components
- Appendix J: Troubleshooting
- Appendix K: Make-up Heat Requirements
Appendix E: Mounting Diagrams
Reinforced
rubber strap
Recirculation
module
Recirculation
module
Bolt to floor
Space must be left to allow connection of
drain lines with adequate slope for drainage
Wooden curb (supplied by others)
U channel
(supplied by others)
Rubber vibration isolator
(supplied by others)
3/8” [10 mm]
threaded rod
(supplied by others)
Note: Diagrams show standard unit configuration.
For units with the reversed door option, the door
will be located here.
Figure E1: HRV600i and HRV1200i mounting
Bolt to floor
Wooden curb
(supplied by others)
Space must be left to allow
connection of drain lines with
adequate slope for drainage
Low voltage
terminal strips
3/8” [10 mm]
threaded rod
(supplied by others)
Cabinet mounted
U channel
Rubber vibration
isolator
Low voltage
terminal strips
Figure E2: HRV700i mounting
VCES-HRV-IOM-1C – HRV600i, HRV700i, HRV1200i
25