User manual

19
NSTALLATION I
The installation must be carried out by a suitably
qualified person, in accordance with the current
version of the following.
o AS/NZS 3000: 2007 Wiring Regulations
o 2010 Electricity Safety Regulations
n
efore connecting the appliance, make sure that the supply voltage
o
WARNING: THIS APPLIANCE MUST BE EARTHED.
5A double pole switched
fused spur outlet, having 3 mm contact separation and placed in
le position adjacent to the appliance. The spur
outlet must still be accessible even when your oven is located in
provided and then immediately close the terminal
block cover again.
o If you have to change the oven power cord, the earthing
(yellow/green) conductor must always be 10 mm longer than the
line conductors.
by an appropriate replacement which can be obtained from the
Electrical connectio
B
marked
voltage.
n the rating plate corresponds with your mains supply
o This appliance should be wired into a 1
an easily accessib
its housing.
o To connect the oven power cord, loosen and remove the cover
on the terminal block, in order to gain access to the contacts
inside. Make the connection, securing the cord in place with the
cable clamp
o Care must be taken to ensure that the temperature of the mains
supply cable does not exceed 50°C.
o If the mains supply cable is damaged, then it must be replaced
Spares Department.