Specifications

Select Receiver Options Optimal Subwoofer Performance
It is important that the audio system’s existing receiver is set up correctly to work in concert with the subwoofer. To set up the receiver refer to its
instruction manual and use one of the following three options:
RECEIVER OPTIONS
OPTION #1 OPTION# 2 OPTION #3
(MOST COMMON) (LESS COMMON) (LESS COMMON)
Wireless Transmitter SETUP
SETUP #1: SETUP #1: SETUP #2:
(MOST COMMON) (MOST COMMON) (LESS COMMON)
Receiver has LFE or SUB output Yes Yes No
Use receiver’s LFE or SUB
output as subwoofer’s input
No Yes Yes
This setup uses the receiver’s, This setup uses the subwoofer’s This setup uses the subwoofer’s
not the subwoofer’s, lowpass lowpass crossover frequency filter lowpass crossover
crossover frequency filter. instead of the receiver’s filter. frequency filter.
RECEIVER OPTION #1
The receiver’s LFE or SUB output is the input to the subwoofer (most common case):
1. Select that you have a subwoofer.
2. Select the number of speakers.
3. Select the speaker size as SMALL.
4. If you don’t know the low frequency limit of your main speakers, use 80 Hz as the crossover point. The lower limit of the main
speaker’s frequency response is usually listed in the speaker specifications as, for example, “3 dB down at 45 Hz.”
In this example, double the value (45 Hz) and use the doubled-value (90 Hz) as the crossover frequency.
5. Adjust the LFE /SUB output level to 0 dB.
6. Go to the Connect Subwoofer instructions next.
RECEIVER OPTION #2
The receiver’s unfiltered/full frequency range R and L output channels, not its LFE or SUB output, is the input to the subwoofer
(less common case).
1. Select that you have NO subwoofer.
2. Select the number of speakers.
3. Select the speaker size as LARGE.
4. If the crossover frequency option is available, double your main speakers specified low frequency response value and select
the result as the crossover frequency. If you don’t know the low frequency response value, use 80 Hz.
5. Go to the Connect Subwoofer instructions next.
RECEIVER OPTION #3
The receiver has no LFE or SUB output:
1. No selections to make.
2. Go to the Connect Subwoofer instructions next.
[9]
WiConnect User’s Manual
SET UP
Yes No No
Use receiver’s unfiltered/full
frequency range R and L
outputs as subwoofer’s inputs