Installation manual

516195-2201
7.3 GS-01 to TD-32 (Analogue)
Data between GS-01 and TD-32 with GS-01 in the dialing end.
GS-01 in the dialling end
AT+CPIN=xxxx Insert PIN number if required
AT+CBST=7,0,1 Bearer type selection. Choose data rate and protocol.
(9 600, V.32)
ATDxxxxxxxxxx Dial the number
AT&W Store active configuration
TD-32 in the receiving end.
Factory default settings except for SW4.
It was set for 9 600,8,N,1 i.e. 2,3,5 and 6 ON.
TD-32 answers automatically after 2 ring signals
7.4 GS-01 to ISDN (ID-90)
The necessary settings to send data between GS-01 and ID-90 (ISDN terminal adapter).
Data between GS-01 and ID-90 (ISDN terminal adapter)
GS-01 in the dialling end
AT+CPIN=xxxx Insert PIN number if required
AT+CBST=71,0,1 Bearer type selection. Choose data rate and protocol.
(9 600, V.110)
ATDxxxxxxxxxx Dial the number
AT&W Store active configuration
ID-90 in the receiving end
AT&F0
AT&F1 Factory default
ATB0 Sets the B channel protocol to V.110 asynchronous
ATN4 Sets line baudrate for B channel protocol V.110 to 9 600 bit/s
AT**V110LLC=1 Sets low layer compatibility to pass detailed information
about the V.110 protocol to the called party.
AT%B4 Sets local baudrate to 9 600 bit/s
AT&W Store active configuration
Generally, the MSN number is given by the network provider (e.g. Telia) including the
area code.
E.g. area code = 016 and subscriber number 480 130 the MSN should be programmed as
AT**MSN=016480130.
If your ISDN-Controller is connected to the internal S0 bus of a PBX, use the MSN of the
respective extension. For more information, please refer to your PBX supplier manual.