Installation manual

476195-2201
+CSCA – Service center address
This command shall be used to indicate to which service center the message has to be
sent.
The GSM module has no default value for this address. If the application tries to send a
message without having indicated the service centre address, an error will be generated.
So, the application has to indicate this address at initialization. This address is then
valid all the time. The application may change it if needed.
Application to GSM AT+CMGS=”[phone]”<CR> Send a message
Hello, how are you?<ctrl-Z>
GSM to Application +CMS ERROR: 330 Service centre unknown
Application to GSM AT+CSCA=”0696741234” Service centre initialisation
GSM to application OK
Application to GSM AT+CMGS=”[phone]” Send the same
<CR> message again
Happy Birthday!<ctrl-Z>
GSM to application +CMGS: 1 Successful transmission
OK
+CSCB – Select Cell Broadcast Message
Command syntax: AT+CSCB= <mode>, [ <mids>, [ <dcss> ] ]
Set command selects which types of CBMs are to be received by the ME, This command
is allowed in both PDU and text modes.
The <bm> parameter of +CNMI command controls the message indication.
Test read command (AT+CSCB?) is not supported.
The activation of CBM reception (<mode>=0) can select only specific Message Identifiers
(list in <mids>) for specific Languages (list in <dcss>), but the deactivation stops any
reception of CBMs (only AT+CSCB=1 is allowed)
Message Identifiers (<mids> parameter) indicates which type of message identifiers the
ME should listen to.
Supported languages (<dcss> parameter) are: 0 for German, 1 for English, 2 for Italian, 3
for French, 4 for Spanish, 5 for Dutch, 6 for Swedish, 7 for Danish, 8 for Portuguese,
9 for Finnish, 10 for Norwegian, 11 for Greek, 12 for Turkish, 13 for Hungarian, 14
for Polish and 32 for Czech.
Application to GSM AT+CSCB=0,”15-17,50,86”, ”” Accept SMS-CB types
15,16,17,50 and 86 in
any language
GSM to Application OK CBMs can be received
Application to GSM +CBM: 10<CR><LF> CBM length of a received
00112233445566778899 Cell Broadcast message
(SMS-CB), CBM bytes in
PDU mode