Installation manual

216195-2201
GSM to application OK Password changed
Application to GSM AT+CPWD=”AO”,1234,5555 Change password
GSM to application +CME ERROR: 16 Wrong password
Application to GSM AT+CPWD=”AO”,5555,1234 Change password
GSM to application OK Password changed
Whatever the facility, the change of password is performed for all calls barring.
+CLIP – Calling line identification presentation
This command allows control of the calling line identification presentation supplementary
service. When the presentation of the CLI (Calling Line Identification) is enabled (and
calling subscriber allows), +CLIP response is returned after every RING (or +CRING)
result code.
Command syntax:
AT+CLIP=<n>
Response syntax:
+CLIP: <n>,<m> for AT+CLIP?
+CLIP: <number>, <type>[,<subaddr>, <satype>, <alpha>]
for an incoming call, after each RING or +CRING indication
<n>: parameter sets/shows the result code presentation in the TA
0 Disable
1 Enable
<m>: parameter shows the subscriber CLIP service status in the network
0 CLIP not provisioned
1 CLIP provisioned
2 Unknown (no network...)
Application to GSM AT+CLIP=1 Enable CLIP
GSM to application OK CLIP is enabled
Application to GSM AT+CLIP? Ask for current functionality
GSM to application +CLIP: <n>,<m> <n> and <m> defined as above
OK
GSM to application RING Incoming call
+CLIP: Incoming call with number and
“070888888”129,1,,, name presentation
“FRED”
Application to GSM AT+CLIP=0 Disable CLIP presentation
GSM to application OK Command valid