Operating instructions
6THE OUTLAW’S GUIDE TO THE SMS-1
REAR PANEL
RP1 XLR LFE Output
Does your subwoofer oer an XLR-style balanced connection? If
so, this is where you will connect the SMS-1 to the subwoofer.
RP2 XLR LFE Input
Does your receiver or processor oer an XLR-style balanced out
-
put for the LFE channel? If so, this is where you will connect the
receiver’s LFE output to the SMS-1.
RP3 Rear Microphone Input
The microphone can be connected to this rear input or to the
front microphone input (FP4).
RP4 IR Input
A remote sensor or distributed IR system can be connected here
so that the SMS-1 can receive IR commands even if the unit is hid
-
den from view.
RP5 RS-232 Output
This can be used to connect to other SMS-1’s if you have several
units in your system.
RP6 RS-232 Input
This can be used to connect to a PC for software updates, a con
-
trol system, or to other SMS-1’s.
RP7 EQ Video Output
Composite and S-video outputs are available to provide the on-
screen menus used to congure the SMS-1. Connect one of these to
your TV, receiver or processor. See the EQ audio output (RP9) below.
RP8 LFE Outputs
Connect up to three subwoofers to the SMS-1 using these LFE
outputs.
RP9 EQ Audio Output
This stereo analog output is used to pass the SMS-1’s test tones
to the receiver or processor. This output must be connected to
an input of your receiver or processor; do not connect this output
directly to your TV. It may be convenient to connect the EQ video
output (RP7) to the same input.