User manual

4 - 40 MicroVision FX
Setting chase output levels
When you record the submasters included in a chase, you assign an
output level to the channels that make up the submaster. After you
record the submasters, you can modify their output level by setting the
level of the potentiometer labeled Effects.
When the Effects pot is set at 10, all chase submasters playback at their
recorded level. When it is set a a level less than 10, the submasters'
output levels equal the current pot setting multiplied by the percentage
level at which the pot is set. For example if submaster levels are re-
corded at full (100 percent) and the Effects pot is set at 5, the step will
output at 50 percent of recorded submaster levels.