User manual

4 - 26 MicroVision FX
Timed fader pairs
When fader controls are set at 10, MicroVision FX plays fade times as
you recorded them. For information on taking manual control of fades,
see the section titled Controlling fades manually later in this lesson.
Playing back cues
To play back the cues you created in Lesson 2 , follow these steps:
1. Press [Stage] to display stage mode.
2. Press [Cue] to indicate that you want to select a cue.
3. Enter the cue number you want to play back. To play back cues you
recorded from Lesson 2, press [1][.][1].
4. Press either [Go] key. Cue 1.1 begins. MicroVision FX assumes that
you want to play cue 2 next.
5. Press [Go] to start cue 2.
If you press [Go] before a cue finishes playing, the previous cue stops
and channels begin fading to the levels determined by the next cue.