User manual

4 - 14 MicroVision FX
Cue 3: Creating a cue with modified fade times
When you create a cue, MicroVision FX assigns default fade times to the
cue. If you prefer, you can modify the fade times using [Time].
Note: Default fade time is factory set at five seconds. For information on
changing default fade times, see page 3 - 14.
To create cue 3 with modified fade times, add channels to the channels
remaining from cue 2.
1. Press [Blind] if the Blind mode screen is not already displayed.
2. Add channels using numeric keypad and [And] or [Thru]; then enter
intensity levels.
3. Press [Time].
4. Enter upfade time between .1 and 99:59. You can enter time either
in minutes and seconds or with a fraction of a second in decimal
format. For example, all of the following are acceptable: .2, 00:12,
5.5, 5:30.
5. Press [Enter].
6. Enter downfade time, if different from upfade time. Enter a time
between .1 and 99:59. If you do not enter a time, MicroVision
assumes you want the same downfade time as upfade time.
7. Press [Enter].
8. Press ]Record] to indicate that you want to record the cue.
9. Enter cue number, and press [Enter].