User manual

3 - 4 MicroVision FX
Entering one-to-one softpatch
If you have the same number of dimmers and channels, you may want
to use a one-to-one softpatch. A one-to-one patch assigns dimmer one
to channel one, dimmer two to channel two, and so on. If you have more
dimmers than channels, the default setting assigns the first extra
dimmer to channel one, the second extra dimmer to channel two, and so
on.
To use MicroVision FX ’s default softpatch setting follow these steps:
1. Press [Set Up].
2. Select 7, System settings, and press [Enter].
3. Select 5, Select default softpatch, and press [Enter].
4. Press [Enter] again to accept the default softpatch settings. Or,
press [Clear] to cancel the operation.
Note: For instructions on performing a channel check from the
patch screen (without returning to Stage mode), see the section
titled Capturing channels in softpatch later in this chapter.