User manual

A - 2 MicroVision FX
Printer is off-line
To continue, press [Clear]
Printer is not connected to the MicroVision FX , printer power
is turned off, or printer is not on line. Check the printer
and try again.
Unable to write disk — write protected
To continue, press [Clear]
The disk is currently write protected. Slide the disk’s write protect tab to
the write enabled position and try again.
Unknown disk error
To continue, press [Clear]
The disk drive has reported an error of unknown type. Try the operation
again. If the error recurs, notify your dealer or authorized service center.
Unrecognized or unformatted disk
To continue, press [Clear]
The disk in the drive is not properly formatted for use in the
MicroVision FX . Format the disk and try again.
Caution: formatting a disk erases its contents.
MicroVision shows cannot be recorded on Vision disks
To continue, press [Clear]
The disk contents were recorded on an ETC Vision console. The
MicroVision FX can read Vision disks, but will not write on them.
If you do not need to save the disk’s contents, you may format the disk
on the MicroVision FX and try again.
Caution: formatting a disk erases its contents.