User manual

7 - 24 MicroVision FX
Full
[Full] enters full intensity for all selected channels. [Full] works in all
display modes. When you use [Full], you do not have to press [At].
Example
[Chan] [5] [Thru] [1][0] [Full] sets channels 5 through 10 at 100 percent.
Resetting default full level
MicroVision FX enters the default full setting for selected channels when
you press [Full]. The default setting for full is 100 percent, and is reset to
100 percent after a diagnostic system clear.
You can reset the default full level at any level you like. Once you set a
new default full level, you can still set channels above the [Full] setting
by using [At], [+], [-], or the fader wheel. To set a new default full level,
follow these steps:
1. Press [Set Up].
2. Select 7, System settings, and press [Enter].
3. Select 3, Default full level, and press [Enter].
4. Either enter a two-digit intensity level, or press [Full] to set levels at
100 percent.
Note: When you set dimmer levels on the softpatch screen, [Full]
enters 100 percent regardless of the default full level setting.