User manual

5 - 14 MicroVision FX
Reading a show from disk
When you read a show from a disk and load it into memory, the new
show overwrites the current show in the board. Therefore, if you want
to keep the current show, follow the instructions on the previous page
to record current show before you read a new show from disk.
Current submaster and cue output levels are not affected when you read
a new show into the console from a disk.
Live submasters remain on stage until you pull their pots to zero. Moving
submaster pots up again loads a submaster from the new disk. On a
color monitor, submasters from the previous show are displayed in
green. Once loaded, the new submasters are displayed in yellow.
Loading a new show automatically loads submaster page one from the
new show.
When a new show is read from disk, cues loaded in the fader pairs
remain in the faders until you remove or replace them. Press [Clear] to
remove them, or replace them by loading a new cue.
To read a show from disk into memory follow these steps:
1. Insert disk in disk drive.
2. Press [Set Up].
3. Select 2, Read show from disk, and press [Enter].
MicroVision FX displays the message, Not recorded, for shows that
are not yet recorded on the disk.
4. Select desired show, and press [Enter]. The show you enter will
overwrite the current show in memory.
Or, press [Clear] to cancel the operation.