User manual

Pro-Magic Plus User Manual

Q30. After changed Pro Magic Plus’ Display Mode”, the screen turned black and keyboard has no

response; reboot computer still get the same results, what should I do?

A30. Your display card or monitor does not support the selected display mode, reboot computer and

continuously press F5 after finished BIOS detection, and Pro Magic Plus will automatically configure

display mode to 680*480, 16 colors state.

Q31. I want to change the ‘Partition Properties’ options under ‘Manager’ of MANAGER mode, but Pro

Magic Plus prompts “Your version does not support this function”.

A31. Your partition is non-standard format partition, so the system will inform it is not supported by the

version. E.g. If second partition is PRI partition, you will be unable to adjust partition property,

because partition property is relating to multi-boot function, and Pro Magic Plus multi-boot function

requires the second OS must be installed on logic partition.

Q32. I am using Windows 2000/XP, and after installed Pro Magic Plus and enter OS under Protection

Mode, it always ask “System configuration has been changed, please reboot computer”. Why? Do I

need to reboot the computer?

A32. Pro Magic Plus will install its driver to the system, and when Windows 2000/XP detected any newly

added driver, it will display this message as a normal procedure. You may select ‘No’ or ‘Save to

Initial Point’ after installation of Pro Magic Plus, and you will not see this message again.

Q33. After installed Pro Magic Plus, when enter OS, system prompts “Display current mode resident icon

failure!” message, and after clicked ‘Ok’, PMMODE icon did not appear on bottom right hand corner’s

task bar. Why?

A33. This is because the system is too busy or is loading other programs and caused conflicts, but it will

not affect Pro Magic Plus’ protection function. When system is stable or close down some

programs that are not in use, and then execute Pro Magic Plus from program file of ‘start’ menu.

Q34.

May I defrag my computer after INSTALLED ProMgic Plus?

A34. Yes, you may defrag your systmer after installed ProMagic Plus.

BUT, please be aware ProMagic Plus' buffer area may be full during defrag,

and a message will prompt to ask you to 'RESTORE' your system.

If you cancel to restore your system, you will not be able to enter Windows.

Once you have restored, you will NEVER be able to retrieve back restored system and data.

To avoid this situation, you have another option to defrag your system after installed ProMagic Plus.

You could run defrag under 'unprotected mode'.

DO NOTE, any actions done under 'unprotected mode' CANNOT be restored using ProMagic Plus.