User manual

Pro-Magic Plus User Manual

Q10. Does Pro Magic Plus support SCSI interface HDD?

A10. Pro Magic Plus supports SCSI on Windows 2000/XP, but DO NOT install Pro Magic Plus on Windows

9x OS, because Pro Magic Plus does not support SCSI interface HDD on Windows 9x OS.

Q11. I have already installed old version of PRO-MAGIC (v5.1/6.0), can I install Pro Magic Plus again?

A11. Yes, but please remove the old version of PRO-MAGIC (using its ‘Remove’ function) before install Pro

Magic Plus.

Q12. Finished installation of Pro Magic Plus under Windows and reboot, and computer stopped a "Starting

Pro Magic Plus …”.

A12. You can use rescue disk for initial stage’s repair (please refer to Appendix B), if you still cannot enter

the system, it may already been damaged, please contact Wasay Service Center for further

assistance.

Q13. After installed Pro Magic Plus under Windows and reboot, the computer stopped at black screen.

A13. Possible causes & solutions as below:

a. Display card’s driver under DOS has bug.

[ S o l u t i o n ] C h a n g e d i s p l a y c a r d o r p l u g H D D t o o t h e r c o m p u t e r a n d f i n i s h P r o M a g i c P l u s

i n s t a l l a t i o n b e f o r e p l u g t h e H D D b a c k t o o r i g i n a l c o m p u t e r .

b. Motherboard BIOS’s internal anti-virus and write-protect functions are activated.

[Solution] Go into BIOS and turn these two functions off.

c. There are too many cards plugged on the motherboard which occupy too much resource or

conflicting with some cards.

[Solution] Try to unplug some cards, finish Pro Magic Plus installation, and then plug them back.

If the solutions above cannot solve the problem, please contact Wasay service center.

Q14. After installed Pro Magic Plus under Windows and reboot, prompts “Insufficient HD space! Please

move data in last partition to other locations and run defrag disk before reinstall again.” Message.

A14. Install Pro Magic Plus requires minimum of 200M usable HDD space, if do not have enough space,

please choose to exit installation and reboot computer to enter Windows OS, release disk space of

last partition and reinstall again. P.S. If you have not format the partition, please format it before

installation.

Q15. “Incorrect HDD partition structure, cannot install. Press “ENETR” to exit installation”.

A15. Pro Magic Plus supported partition format is (1). PRI + PRI; (2). PRI + Logic (20 max.). If your

partition is non of the two above, please do not install Pro Magic Plus. You can boot with boot disk

and execute FDISK to check your partition status.

Q16. “There is NON-DOS partition at the end of your HDD, install this software will damage data of the

partition, sure to continue?”

A16. Pro Magic Plus will let user choose the size of backup buffer area (100M, 200M, 500M, 1G), and will

occupy disk space at end of HDD according to the chosen size. If your last partition is NON-DOS

partition, Pro Magic Plus will see it as remaining space and may damage data in that partition, so

there is possible danger. You can choose to cancel to install Pro Magic Plus to avoid data damage

and lose.

Q17. I set the startup method to ‘Hide Menu’ option and will directly boot into OS. How to display Pro

Magic Plus DOS mode menu again?