Specifications

TM 05539-IN

REMOVAL OF BARRELED RECEIVER FROM STOCK - CONTINUED 0016 00

0016 00-3/(0016 00-4 Blank)

INSPECTION - CONTINUED

5. Inspect the trigger guard screws (2 and 4) for wear, unserviceable threads, and correct length. If unserviceable or incor-

rect length, evacuate to higher level maintenance.

REASSEMBLY

1. Place the barreled receiver in the stock and press straight down on the receiver over the recoil lug. Ensure barreled

receiver is fully seated in stock.

CAUTION

• When installing the trigger guard screws, ensure that the short screw goes into the hole in the front por-

tion of the trigger guard.

• The long screw goes into the rear hole next to the trigger guard bow.

2. Install the forward trigger guard screw (4) first, followed by the rear trigger guard screw (2). Snug both trigger guard

screws by hand. Using a torque wrench, tighten to setting specified in the Weapon Record Book. Torque the forward

trigger guard screw first, then the rear trigger guard screw.

3. Once the weapon is completely reassembled, perform the Function Check. Refer to WP 0020 00.

4. Install suppressor if necessary (TM 05539-OR_).

END OF WORK PACKAGE

M40-023

M40-020A