Specifications

TM 05539-IN

SKIM GLASSING - CONTINUED 0026 00

0026 00-8

SKIM GLASS CLEAN UP

1. Clean the barreled receiver, trigger guard, and the receiver screws of all epoxy, tape, and clay and set them aside.

NOTE

Ensure bolt handle clears stock when re-bedding the stock.

2. Clean up stock and make all clearance cuts.

a. Using a wood chisel, bevel glass area for recoil lug (22), front of barrel pad (28), and both front (23) and rear (24)

screw holes. Use a bearing scraper on bottom of stock.

b. Clear glass area (25) to prevent bolt release pin from touching glass wall.

c. Clear glass area (26) to prevent rear trigger pin from touching glass surface.

d. Clear glass area (27) to prevent front trigger pin from touching glass surface.

END OF WORK PACKAGE

M40-072