Specifications

TM 05539-IN

SKIM GLASSING - CONTINUED 0026 00

0026 00-5

SKIM GLASSING - CONTINUED

2. Insert the trigger guard (11) inside the stock (17) and secure with masking tape (19).

NOTE

• Ensure all areas are filled with epoxy/glass.

• Fill lug mortise with epoxy/glass and pack in corners.

3. Invert stock (17) top-side up in vise and apply a light to moderate coat of epoxy/glass into the top bedding surface (15)

of the stock.

4. Carefully place the barreled action into the stock, ensuring that alignment is maintained between the stock and the

action.

5. With weapon upright, clean excess glass out of trigger guard screw holes before inserting screws.

6. Insert the trigger guard screws, ensuring that the front screw (shortest screw) is tightened first. Slowly tighten both

screws until slight pressure is felt.

7. Torque the trigger guard screws (front first) to 60 lb-in.

8. Pack glass on all edges and clean up excess epoxy/glass from the weapon.

9. Set the weapon aside to dry for at least 24 hours. Do not allow it to rest on either the barrel or the trigger guard. Ensure

nothing touches the barreled receiver or trigger guard while epoxy/glass dries.

M40-070

M40-068b