Specifications

TM 05539-IN

SKIM GLASSING - CONTINUED 0026 00

0026 00-2

PREPARATION FOR BARREL AND RECEIVER

NOTE

Curing and drying time, including ambient temperature requirements, should be according to manu-

factures’s recommendations.

1. Insert modeling clay inside following cavities on the bottom and side of the receiver (5), gas port hole (4), right side trig-

ger pin holes (6), and trigger guard screw holes (7). Trim clay with a putty knife flush with the receiver. Clean receiver

with acetone.

2. Tape the barrel (10) with 2-in. masking tape (1) (3 wraps) and 1.5-in. masking tape (3) on the front of the recoil lug (2)

and apply a 1/8 in. clay bevel to each side of the recoil lug.

3. Tape the bottom and sides of the recoil lug (2), wrapping twice with masking tape (1). Trim the overhang of masking

tape. The masking tape should come to 3/8-in. (8) on both sides of the recoil lug.

M40-066