Specifications

TM 05539-IN

STOCK ASSEMBLY - CONTINUED 0025 00

0025 00-3/(0025 00-4 Blank)

REASSEMBLY

1. Install inserts (4) and recoil pad (5) on stock (3).

2. Install recoil pad screws (6) in stock (3).

3. Install cheek piece (1) on stock (3) and install cheek piece screws (2).

4. Place the barreled receiver in the stock and press straight down on the receiver over the recoil lug. Ensure barreled

receiver is fully seated. Refer to procedures outlined in Removal of Barreled Receiver from Stock (WP 0016 00).

NOTE

Trigger guard screws are different lengths. Ensure that long screw is installed in the rear and the

short screw is installed in the front.

5. Place trigger guard assembly in stock and install trigger guard screws until hand tight.

6. Using a torque wrench, tighten to the settings specified in the Weapon Record Book.

END OF WORK PACKAGE

M40-026