Specifications

TM 05539-IN
SAFETY AND TRIGGER MECHANISM - CONTINUED 0024 00
0024 00-11
STAKING THE RECEIVER
CAUTION
To prevent damage to the receiver, DO NOT stake receiver too close to the edge of the trigger pin hole
or too deep. Be careful not to damage trigger assembly while staking.
1. Place weapon upside down in vise with trigger and trigger pins inserted.
2. Using a 1/8-in. center punch and 8-oz ball peen hammer, stake the bottom of the receiver in the three positions.
3. The staking should not be any deeper than necessary to tighten the trigger pin in the trigger pin hole.
REPLACE UNSERVICEABLE TRIGGER
1. Inspect new trigger assembly.
2. Install on receiver. Refer to procedures outlined in this work package.
M40-059
1
2
3
BOTTOM VIEW
LEFT SIDE
RIGHT SIDE