Specifications

TM 05539-IN

SAFETY AND TRIGGER MECHANISM - CONTINUED 0024 00

0024 00-6

DISASSEMBLY - CONTINUED

6. Using a 1/8-in. punch and 4-oz hammer, drive out the trigger pin (14) from trigger housing assembly (4).

7. Remove trigger (15) and connector from trigger housing assembly (4).

8. Clean or replace trigger parts as required.

ASSEMBLY

1. Align trigger (15) and connector in trigger housing assembly (4) and install trigger pin (14) using a 1/8-in. punch and

4-oz hammer.

2. Place bolt stop release (3) on trigger housing assembly (4) and insert safety (9). While maintaining proper alignment,

insert safety pivot pin (13) from the left side of trigger assembly through the bolt stop release and safety. Install the

safety ball (10) and safety detent spring (12).

3. Install retainer clip (11) over safety pivot pin (13) using a jeweler’s screwdriver (.080).

M40-055