User`s guide
AT&T Global Network Client for Windows Administrator’s Guide
© 2015 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T logo and all other AT&T marks contained herein are trademarks of AT&T Intellectual Property and/or
AT&T affiliated companies. All other marks contained herein are the property of their respective owners. Images are shown for illustrative purposes only; individual
experience may vary. This document is not an offer, commitment, representation or warranty by AT&T and is subject to change.
Windows is a registered trademark of Microsoft Corporation in the United States and other countries.
-72-
The table below defines the settings configurable using the NetworkAwareness.xml.
Stanza Description
network_location A brief description of network – this is displayed
on the AT&T Global Network Client user
interface so the name should be kept short to
preserve readability.
ONLY ONE network_location stanza may be
defined in the NetworkAwareness.xml file.
Active Set to “Y” for the AT&T Global Network Client to
actively look for and perform an action for this
network location. Set to “N” to perform no
action.
Action Set to one or more available actions:
IMMEDIATELY_DISCONNECT
PROMPT_TO_DISCONNECT
MINIMIZE_CLIENT
Subnet Set to one or more IP address/subnet mask
combinations to define the network. Multiple
subnets can be defined by repeating this stanza
within the network location stanza.
dns_suffix_list Set to DNS suffix to identify network location.
Multiple suffix’s can be defined by separating
suffix’s with a comma. Multiple suffixes within
the list are combined using “OR”.
dns_server_list Set to DNS Server IP Addresses to identify
network location. Multiple IP Address’s can be
defined by separating IP Address’s with a
comma. Multiple IP Addresses within the list
are combined using “OR”.
wins_server_list Set to WINS Server IP Addresses to identify
network location. Multiple IP Address’s can be
defined by separating IP Address’s with a
comma. Multiple IP Addresses within the list
are combined using “OR”.
Operator Set to “OR” or “AND” to determine how to
combine multiple types of identifiers (subnet,