User`s guide
AT&T Global Network Client for Windows Administrator’s Guide
© 2015 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T logo and all other AT&T marks contained herein are trademarks of AT&T Intellectual Property and/or
AT&T affiliated companies. All other marks contained herein are the property of their respective owners. Images are shown for illustrative purposes only; individual
experience may vary. This document is not an offer, commitment, representation or warranty by AT&T and is subject to change.
Windows is a registered trademark of Microsoft Corporation in the United States and other countries.
-50-
Public Properties
The installation packages contain a number of public properties that can be set on the command line or
within a transform. The properties in the table below govern some behaviors of the setup.
Important Note: Some public properties should not be used along with the CONFIG_FILE public property.
Some public properties (noted with “Use XML”) will generate a config.xml which will be overwritten by
the CONFIG_FILE. If using CONFIG_FILE, please include all customizations in the config.xml only.
Property Use
XML
Intended Use & Value Information
ACCOUNT
X
This property can be set to pre-configure the account
used to connect to the network
AUTOCONNECT_CONTROL_ALLOWED
X
Set this property to “yes” to show the Automatic Mobile
Connection option on the Mobile Menu.
Default: “yes”
CELLULAR_ROAMING_ALLOWED
Set this property to “yes” to allow the AT&T Global
Network Client to connect while the mobile device is
roaming, OR “no” to prevent the AT&T Global Network
Client from connecting while the mobile device is
roaming, OR “prompt” to prompt the user before
connecting while the mobile device is roaming.
Default: “prompt”
CERT_SHOW
X
Set this property to “Y” to set the AT&T Global Network
Client to show the “Login using a Digital Certificate or
Smart Card” checkbox on the User ID panel of the Setup
Wizard.
Default: blank (not set)
CERT_SHOW_SET
X
Set this property to “Y” to select the “Login Using a
Digital Certificate or Smart Card” checkbox for all new
user profiles.
Default: blank (not set)
CERT_DEFAULT_USE
Set this property to “1” to make the AT&T Global
Network Client look for certificates only on the Smart
Card.
Default: blank (not set)