User guide

ALEOS 4.2.3 User Guide
50 20080616
DHCP/Addressing
This section is primarily a status display of the configurations with a few options
which are global to all interface types. Interfaces which are enabled in the current
configuration will be displayed with their configured settings.
DHCP addresses and subnets are assigned to the physical LAN side interfaces
display. When WiFi is bridged to Ethernet, Ethernet and WiFi are on the same
subnet display.
Note: If the device has not been reset since configuration changes were made, the current
configuration in use may be different.
Figure 5-1: ACEmanager: LAN - DHCP/Addressing
Note: Bridging between the WLAN and USBnet is not supported.
Field Description
Host Connection
Mode
Sets the Host Interface that uses the Public IP address granted by the cellular network or if
all should use private IP addresses. All host interfaces which are not using the public IP
address will use private IP addresses.
0 = Ethernet Uses Public IP;
1 = All Hosts Use Private IP's - (Default)
2 = USB Uses Public IP
Note: The connected computer receives the DHCP address from ALEOS and, it also has
the default router set up to device IP.
Lease Timer (secs) Configurable DHCP lease time.
MTU Sets the maximum transmission unit size.
Bridge WiFi to
Ethernet
Displays the state of the WiFi bridge to the Ethernet: Enabled or Disabled.
LAN Address
Summary
Displays the interfaces which have been enabled. By default, only the Ethernet and
USBNET Interfaces are enabled.