User guide

WAN/Cellular Configuration
Rev 2.3 Feb.12 45
Advanced
1x/EV-DO
and HSPA/
GPRS
Response
to
Incoming
Ping
When a ping is received by the device from a remote location, the Response to
Incoming Ping will redirect it to the selected location.
• No response: the incoming ping will be completely ignored
• ALEOS Responds (default): ALEOS will return to the Ping response.
• Pass to Host: The ping will be forwarded to the DMZ host with any response
from the host forwarded back to the OTA location. If no host is connected, there
will be no ping response.
Note: Some carriers may block all ICMP traffic on their network. A ping sent to the
device from a remote location will not be received.
1x/EV-DO
and HSPA/
GPRS
Network
Authentica
-tion Mode
Specifies the authentication method to be used in the network PPP session.
• PAP (default) and CHAP are the two options.
1x/EV-DO
and HSPA/
GPR
Network
User ID
Network User ID
The login that is used to login to the cellular network, when required.
• uid=user id (up to 64 bytes)
1x/EV-DO
and HSPA/
GPR
Network
Password
Network Password is the password that, when required, is used to login to the
cellular network.
pw=password (30 characters maximum).
1x/EV-DO Check
profile 1
Params
Enables checking and updating the Profile 1 Parameters.
Not all carriers or account types support this featur
1x/EV-DO NAI Sets the Network Access ID.
Not all carriers or account types support this feature.
1x/EV-DO PHA Sets the IP address of the primary home agent.
Not all carriers or account types support this feature.
1x/EV-DO SHA Sets the IP address of the secondary home agent.
Not all carriers or account types support this feature.
1x/EV-DO MHSS Sets the home agent shared secret key.
Not all carriers or account types support this feature.
1x/EV-DO MASS Sets the AAA shared secret key.
Not all carriers or account types support this feature.
All Network
Watch Dog
(mins)
Network connection watchdog: The number of minutes to wait for a network
connection. If no connection is established within the set number of minutes, the
device resets.
• n=0: Disabled.
• n=minutes: Default = 120 min.
CarrierType Command Description