User guide

Rev 2.3 Feb.12 243
*PPREPORTINPUTS Enable input reporting.
• n=0 : Disabled
• n=1 : Enabled
Note: If both AT*PPCOM1000=1 and AT*PPREPORTINPUTS=1 are
enabled, the AirLink Device digital inputs will be reported and the COM1000
inputs will be ignored.
*PPGPSDATUM Specifies the GPS datum to use for position reports. For accurate results, this
value should match the datum used by receiving mapping application.
• n=0 : WGS84
• n=92 : NAD27
• n=115 : NAD83
*PPTCPPOLL Specifies the port to listen on for TCP GPS report polling. The request to this
port needs to come from the same IP address in *PPIP.
• n=0 : Disabled
• n=1-65535 (default 9494)
*UDPRGPS Set or query GPS stamping of UDP Reliable packets. When set, data received
on the host serial port will be encapsulated with the GPS date and time.
• n=0 : Disabled (default)
• n=1 : Enabled
*PPIGNOREIP When enabled, ignore ATS Server IP (*PPIP) updates in RAP.
• n=0 : Use ATS Server IP updates.
• n=1 : Ignore ATS Server IP updates.
*PPCOM1000 Enables support for extra inputs from a COM1000.
• n=0 : Disable
• n=1 : Enable
Tip: If both AT*PPCOM1000=1 and AT*PPREPORTINPUTS=1 are enabled,
the AirLink Device’s digital inputs will be reported and the COM1000 inputs
will be ignored.
Table E-20: GPS: Misc (Continued)
Command Description