User guide

Rev 2.3 Feb.12 241
*PPGPSR GPS report type.
• n=0 : Use legacy reports specified in *MF value. Note: Must also have
*PPDEVID=0.
• n=0x11 : Standard GPS Report
• n=0x12 : Standard GPS Report + UTC Date
• n=0x13 : Standard GPS Report + UTC Date + RF data
• n=0xD0 : Xora reports.
• n=0xE0 : GGA and VTG NMEA reports
• n=0xE1 : GGA, VTG and RMC NMEA reports
• n=0xF0 : TAIP reports
• n=0xF1 : Compact TAIP data
*PPSNF Store and Forward will cause GPS reports to be stored up if the MP goes out
of network coverage. Once the vehicle is in coverage the GPS reports will be
sent en masse to the server.
• n=0 : Disabled
• n=1 : Enabled (default)
*PPDEVID Whether or not the MP should include the 64-bit device ID in its GPS reports.
*PPDEVID MUST be 1 if the device uses a Dynamic IP.
• n=0 : Disable ID.
• n=1 : Enable/display ID.
*PPSNFR Store and Forward Reliability: GPS reports will be retransmitted if not
acknowledged by the server.
• n=0 : Disabled
• n=1 : Reliable mode enabled for RAP messages
• n=2 : Simple reliable mode
*PPSNFB Store and Forward Behavior. When *PPSNF=1, the type of Store and Forward
behavior is defined by:
• n=0 : Normal Store and Forward. Data is stored when the MP is out of
cellular coverage; when the MP is in coverage, data is sent to server as
soon as possible. This is the default form devices with RAP version 1.3 or
lower.
• n=1 : Data sent only when polled. Data is stored until polled using the
Poll command sent by a server.
• n=2 : Grouped Reports. Data is stored until the desired minimum number
of reports (see *PPSNFM) has been stored. The data is then sent to the
server in groups with at least the specified number of reports.
Table E-19: GPS: Server 1 (Continued)
Command Description