User guide

Rev 2.3 Feb.12 235
SMTP
*RESETPERIOD In PASSTHRU mode, device will be reset after this period if no data has been
sent or received. Value is in hours.
• n=0 : Disabled
• n=1-255 hours
*CSX1 PassThru Echo: Echo data to the host.
• n=0 : Data will be passed to the host.
• n=1 : PASSTHRU mode will echo all host received data and will not pass
the data to the device while the device is not asserting DCD.
Note: If the device is asserting DCD, data will be passed from the host to the
device as it normally is when *CSX1=0.
Table E-13: Common: PassThru (Continued)
Command Description
Table E-14: Common: SMTP
Command Description
*SMTPRADDR Specify the IP address or Fully Qualified Domain Name (FQDN) of the SMTP
server to use.
• d.d.d.d=IP Address
• name=domain name (maximum: 40 characters).
*SMTPFROM Sets the email address from which the SMTP message is being sent.
• email=email address (maximum: 30 characters).
*SMTPUSER The email account username to authenticate with the SMTP server
(*SMTPADDR) for sending email.
• user=username (maximum: 40 characters).
Note: Not required to use SMTP settings but may be required by your cellular
carrier.
*SMTPPW Sets the password to use when authenticating the email account
(*SMTPFROM) with the server (*SMTPADDR).
• pw= password
Note: Not required to use SMTP settings but may be required by your cellular
carrier.
*SMTPSUBJ Allows configuration of the default Subject to use if one isn't specified in the
message by providing a “Subject: xxx” line as the initial message line.
• subject=message subject