User guide

ALEOS 4.2.3 User Guide
222 20080616
Status
Most of the commands in the “Status” group have read-only parameters and
provide information about the device. Most of the commands in the “Status” group
have read-only parameters and provide information about the device. The Status
Group has more fields that can be displayed on most screens. You can either
resize your window or use the scroll bar on the side to display the remainder.
*DEVICEID? The commands displayed in AceManager and the results of those commands
depends on the model of the device. This command will retrieve the 64-bit
device ID the device uses to identify itself to the cellular network.
*ETHMAC? MAC address of the Ethernet port
I Model
I1 ALEOS software/firmware version, hardware rev string, boot version
I2 Radio model and firmware version
I3 Radio ESN or IMEI
Table E-1: Info Commands (Continued)
Command Description
Table E-2: Status: Network
Command Description
*NETIP? The current IP address of the device reported by the internal module,
generally obtained from Carrier your cellular carrier. This is the address that
can contact the device from the Internet.
Use *NETALLOWZEROIP if you need to allow the display of an IP ending in a
zero.
Note: If there is no current network IP address, 0.0.0.0 may be displayed.
*NETRSSI? The current RSSI (Receive Signal Strength Indicator) of the AirLink device as
a negative dBm value.
Tip: The same information is displayed with the command S202?.