User guide

Rev 2.3 Feb.12 221
E: AT Commands
• AT Command Set
Summary
• Reference Tables
• Common
AT Command Set Summary
The reference tables are presented in strict ASCII alphabetical order
(including prefixes). This format allows quick look-up of each
command to verify syntax, parameters, and behaviors. It does not
lend itself to finding whether or not the AirLink Device has a
command to perform a particular service or setting.
The summary in this section organizes the commands into functional
groups to allow you to more quickly locate a desired command when
you know the operation but not the command.
Note: Some of the configuration commands listed here are only available as
AT commands and some commands require having the device in Passthru
mode.
Reference Tables
Result codes are not shown in the command tables unless special
conditions apply. Generally the result code OK is returned when the
command has been executed. ERROR may be returned if
parameters are out of range, and is returned if the command is not
recognized or is not permitted in the current state or condition of the
AirLink Device.
Info
The commands in the “Info” group have read-only parameters. They
only provide information about the device. The commands displayed
in ACEmanager and the results of those commands depends on the
model of the device. The commands in the “Info” group have read-
only parameters. They only provide information about the device.
Table E-1: Info Commands
Command Description
*ETHMAC? The MAC address of the Ethernet port.
*NETPHONE? The device's phone number, if applicable or obtainable.