User guide

ALEOS 4.2.3 User Guide
150 20080616
UDP Connect Last If enabled, sets S53 to the last accepted IP address through UDP auto answer. This can be
used in conjunction with MD3 so that when there is no UDP session, new ethernet host
data will cause a connection to be restored to the last IP accepted through UDP auto
answer.
• Do not change S53
• Set S53 last IP
Default: Do not change S53
Allow Any Incoming IP Allow any incoming IP address to connect when UDP auto answer is enabled (S82=2) or
only S53 to connect when UDP Auto Answer mode is enabled (S82=20). This is subject to
the trusted IP Address filters. Options:
• Allow only S53
• Allow any IP address
Default: Allow only S53.
Allow All UDP Accepts UDP packets from all IP addresses when a UDP session is active. If there is no
UDP session active, an incoming UDP packet will be treated according to the UDP auto
answer and AIP settings. Options:
• No effect
• Allow all
Default: No effect
UDP Auto Answer
Response
Half-Open Response - In UDP auto answer (half-open) mode. Options:
• n=0 : No Response - No Response codes when UDP session is initiated.
• n=1 : RING CONNECT - RING CONNECT response codes sent out serial link before
the data from the first UDP packet.
Note: Quiet Mode must be Off.
Dial UDP Always The dial command always uses UDP, even when using ATDT. Options:
• n=0 : Disable - Dial using the means specified (default).
• n=1 : Enable - Dial UDP always, even when using ATDT.
Note: When this parameter is set you cannot establish a TCP PAD connection.
UDP Serial Delay
(.1 secs)
Waits the specified delay before sending the first received UDP packet and the subsequent
UDP packets out to the port Ethernet (in 100 ms units).
• n=0 : No UDP packet delay (Default).
• n=1 - 255 : Delay in 100ms units, from 100 ms to 25.5 sec.
Table 11-1: Serial Port Configuration
Field Description