User guide

ManualsBrandsVelocity ManualsComputer equipmentEdge GX440

141

142

143

144

145

146

147

148

149

150

Events Reporting Configuration

Rev 2.3 Feb.12 143

Miscellaneous Data includes temperature rates and other information that does

not fit in the other categories.

· Enable for Power In - The voltage level of the power coming in to the

AirLink device at the time of the report.

· Enable for Board Temperature - The temperature of the internal hardware

of the AirLink device at the time of the report.

· Enable for Host Comm State - The signal level between the AirLink device

and the connected device(s).

· Enable for CDMA HW Temperature - The temperature of the internal

radio module.

· Enable for CDMA PRL Version - PRL version in use by the AirLink device.

·Enable for EC/IO - The energy level of the signal from the cellular network.

· Enable for Cell Info - The GPRS cell information for the AirLink device.

Note: For each group you can enable individual fields.

Relay

The relay outputs on the AirLink device I/O port can be used to cause an external

action.

•1 - Relay 1 - Open

• 2 - Relay 1, Inverted - Closed

The relays are capable of switching small loads. If you need a stronger signal,

such as to open some door locks, you can connect the AirLink device’s relay to a

stronger solenoid relay which has enough power to cause the desired effect.

Configure Events

To configure events,

1. Enter an Event Description. The event description will be displayed in the

Events group in the left hand side panel.

2. Select any action and click on Add Action. Then select any Action Type and

configure accordingly.

3. Click on Save and the action will be displayed in the Available Actions menu.

Events Protocol

The Events Reporting protocol is a collection of messaging formats. The

messages are sent to the Reports Server.

The Events Protocol includes four message types.

• 1 - Type, Length, Value - The TLV consists of the MSCI ID as the type, the

length of the data, and the actual data.

•2 - Binary - A binary condensed form of the TLV message will be sent.

• 3 - ASCII - An ASCII condensed and comma deliminated form of the TLV

message will be sent.