User guide

GPS Configuration
Rev 2.3 Feb.12 129
Advanced
GPS Coverage Allows an AirLink device to be configured to send GPS sentences out of the serial port
when the device loses cellular coverage. This feature is configured by 2 fields. This field
controls the status of the sentences. Options:
• ALWAYS
• Out of Coverage
Default: ALWAYS
GPS Report Delay
(secs)
A 16-bit value that is the number of seconds to wait when “Out of Coverage” occurs before
switching to sending the messages out the serial or USB/serial port.
LATS
Local Reporting Time
Interval (secs)
LATS (Local ATS) - Causes GPS reports to be sent out over the Ethernet link every n
seconds when there is an Ethernet, USBnet, or PPPoE connection to the serial host or a
connection to the Ethernet port is established.
• Disable
• 1-255 seconds
Local Report Type Indicates the type of GPS report to send to the local server.
Sets one of the following Local Report types:
• GPS Data
• GPS+Date
• GPS+Date+RF
• GPS+Date+RF+EIO
• NMEA GGA+VTG
• NMEA GGA+VTG+RMC
• TAIP data
• TAIP Compact data
• TAIP LN report
• TAIP TM report
Default: GPS+Date
Starting Destination
Port
Identifies the initial Destination Port to send the reort to via UDP.
Number of Extra
Destination Ports
Indicates the number of additional destination ports that the report is to be sent to.
Device ID in Local
Reports
Indicates the Device ID to use in Local Reports. Options:
• None
• Phone Number
• ESN/IMEI
Default: None
Local Report
Destination IP
Indicates the address of the destination IP to use in Local Reports.
Table 9-2: GPS: Local/Streaming
Field Description