User guide

Services Configuration
Rev 2.3 Feb.12 111
Trusted Phone Number
Follow the instructions below to add a Trusted Phone Number on the SMS page.
1. Send an SMS command to the device and hit Refresh. If Trusted Phone
Number is enabled, no will be performed on the message.
2. Once you have the Last incoming Phone number, that shows up on the SMS
screen in ACEmanager, note the exact phone number displayed.
3. Click on Add More to add the Trusted Phone Number.
Note: The Trusted Phone number can be 15 characters and has to be numbers only.
Note: Phone Numbers (both trusted and not trusted) will be displayed in the Last Incoming
Phone number field.
4. Enter the Last incoming Phone number as the Trusted Phone Number.
5. Click on Apply.
Note: Do not enter any extra digits and use the Last Incoming displayed as a guide to type
the phone number. Use “1” only if it is used in the beginning of the Last incoming Phone
number.
With Trusted Phone Number enabled, only those SMS messages from Trusted
Phone Numbers will receive responses to commands or messages acted on, as
applicable.
SMSM2M
SMS messages can be sent from the serial command interface. Enter
AT*SMSM2M=”[phone] [message]”. The phone number needs to be in the same
format as numbers entered in the Trusted Phone Number List. The message
needs to be 140 characters or less. To send several messages back to back, you
need to wait for the OK before sending the next.