User guide

Services Configuration
Rev 2.3 Feb.12 109
Field Description
SMS Mode There are four SMS message modes that the user can select in the SMS Mode section.
The options are:
• Not Enabled (Default)
• Control Only
• Gateway Only
• Control and Gateway
ALEOS Command
Prefix
The ALEOS Command Prefix is a configurable string of characters that shows up if you
chose Control Only mode or Control and Gateway mode. This field does not display if
Gateway Only mode is selected.
Any SMS command sent to the device needs to be prepended by the prefix.
For example, “&&&Status” sent to device will receive the status command response.
Note: ALEOS Command Prefix can be blank in Control Only mode.
Local Host IP IP address of the attached local host.
Local Host Port The UDP port the host is listening to.
ALEOS Port The UDP port on which the AirLink device is listening.
Start Field Start the SMS message with a delimiter. The packet sent to the host will have a start and
an end delimiter which enclose the message.
Field Delimiter What you want as your SMS message field delimiter. The packet sent to the host will have
a start and an end delimiter which enclose the message.
End Field End the SMS message with a delimiter. The packet sent to the host will have a start and an
end delimiter which enclose the message.
ACK Field ALEOS will provide an ACK for message acknowledgement on every SMS message when
it is passed to the radio. If ALEOS does not send an ACK, wait for 30 seconds and retry.
Default: ACK.
Message Body Format The only SMS body format available is the ASCII Hex. The other types of SMS body
formats are set SMS protocols. Default: ASCII Hex
Trusted Phone
Number
Options: Enable or Disable.
Last Incoming Phone
Number
The last inbound phone number is displayed here. This will only be erased with a reset to
defaults.
Last Incoming
Message
The last incoming message is the last inbound SMS from the phone number.This will only
be erased with a reset to defaults.
Trusted Phone
Number List
Trusted phone numbers are listed here.